[Free] 2017(July) EnsurePass Examcollection Cisco 200-001 Dumps with VCE and PDF 21-30

Ensurepass.com : Ensure you pass the IT Exams
2017 July Cisco Official New Released 200-001
100% Free Download! 100% Pass Guaranteed!

Implementing Cisco Video Network Devices (VIVND)

Question No: 21

Which two of these support an ad-hoc conference call? (Choose two.)

  1. Cisco TelePresence Multiway with Cisco TelePresence Multipoint Control Unit and Cisco TelePresence Video Communications Server

  2. using the Cisco TelePresence Management Suite Scheduler to schedule a conference call to start in 5 minutes

  3. using the Booking tab in the Cisco TelePresence Management Suite to configure a new conference

  4. using the tab Administrative Tools gt; Configuration gt; Conference Settings in the Cisco TelePresence Management Suite

  5. pressing the conference button on a Cisco Unified IP Phone 8941 to conference in a third call

Answer: A,E

Question No: 22

Which statement is correct regarding the difference between Multisite and Multiway conferencing?

  1. Multisite requires configuration on the endpoint, whereas Multiway requires the Multiway options key to be installed.

  2. Multisite requires the presence of a multipoint control unit, whereas Multiway relies on the endpoint conferencing capability.

  3. Multisite is used to conference in multiple sites, whereas Multiway is intrasite multipoint conferencing.

  4. Multisite requires the Multisite options key to be installed and configured at the endpoint, whereas Multiway requires a Cisco TelePresence Video Communications Server and a centralized multipoint control unit.

Answer: D

Question No: 23

You have been informed from the field that a new Cisco TelePresence video endpoint has been deployed with an IPv4 address of Which three devices could you use to see if the endpoint is registered and available for a call? (Choose three.)

  1. Cisco Unified Communications Manager server

  2. Cisco Gigaswitch Router

  3. Cisco TelePresence Manager Suite server

  4. Active Directory server

  5. Cisco TelePresence Video Communication Server

  6. Cisco 3250 Layer 2/3 Switch

Answer: A,C,E

Question No: 24





The C-Series endpoint (codec) does not register with the Video Communication Server that is located in a different network. Based on the exhibits, what could be causing the issue?

  1. The subnet mask on the codec is incorrect.

  2. The ip address of the codec is incorrect.

  3. The interface that the codec is in is in the wrong VLAN.

  4. The codec did not receive a DHCP address from the DHCP server.

Answer: A

Question No: 25

During the initial setup of the Cisco TelePresence System 500, you are required to do an initial camera setup that fails. What might be a primary reason that the failure occurs?

  1. The camera cannot focus on the target.

  2. The room is too dark.

  3. The system is too far away from the target.

  4. The cable to the camera is not connected correctly.

Answer: B

Question No: 26

When you register the Cisco TelePresence System 500-32 video system with the Cisco Unified Communications Manager, what is the most important item for the registration to be input into the server?

  1. the IPv4 address of the Cisco TelePresence System 500-32

  2. the IP telephone media access control address that is used to manage the system

  3. the media access control address of the Ethernet port of the Cisco TelePresence System 500-32

  4. The Cisco TelePresence System 500-32 will always automatically register with the Cisco Unified Communications Manager server.

Answer: C

Question No: 27

Which two issues does utilizing an IP network storage solution for IP video surveillance help overcome? (Choose two.)

  1. analog to IP conversion

  2. large, expandable storage space

  3. physical security

  4. scalability

  5. faster bit rate for storage

Answer: B,D

Question No: 28

Which of these needs to be enabled in Cisco Unified Communications Manager in order for the Cisco TelePresence System 500-32 to be able to share a presentation with a Cisco TelePresence System Codec C40 endpoint that is registered to a VCS?

  1. allow iX application media

  2. send send-receive SDP in mid-call invite

  3. allow presentation sharing using BFCP

  4. allow presentation sharing using H.235

  5. deliver conference bridge identifier

Answer: C

Question No: 29

Which two additional items can be configured for an endpoint to register with the Cisco TelePresence Video Communication Server for H.323 to function correctly? (Choose two.)

  1. unique system ID

  2. unique H.323 ID

  3. unique DNS entry ID

  4. unique E.164 alias

  5. unique real-time transport protocol port numbers

  6. unique NTP server IPv4 address

Answer: B,D

Question No: 30

Refer to the exhibit.


Under which tab can the registration status for the endpoint be found?

  1. Diagnostics

  2. Configuration

  3. Call Control

  4. Maintenance

Answer: A

100% Ensurepass Free Download!
Download Free Demo:200-001 Demo PDF
100% Ensurepass Free Guaranteed!
Download 2017 EnsurePass 200-001 Dumps
Get 10% off your purchase! Copy it:TJDN-947R-9CCD [2017.07.01-2017.07.31]

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 EnsurePass IT Certification PDF and VCE