Cisco CCNP 642-902 Exam 78

Ensurepass

QUESTION
Refer to the exhibit. BGP has been configured on the routers in the network. However, the IBGP peers in autonomous system 65200 have not converged. In addition, this console message was generated on router R2:

*Mar 1 03:09:07.729: %TCP-6-BADAUTH No MD5 digest from 10.10.23.2(179) to 10.10.23.3(11002)

On the basis of the information that is provided, what is the cause of the problem?

A. BGP authentication can be used on eBGP peers only.
B. The password that is used for BGP authentication on both BGP peers in autonomous system 65200 must be the same.
C. BGP authentication can be used on iBGP peers when the connection is configured between the loopback interfaces.
D. OSPF must be configured with the same MD5 authentication.

Correct Answers: B

QUESTION 382
The command bgp always-compare-med is added to a router configuration. What will this command accomplish?

A. forces the router to compare metrics of routes from different autonomous systems
B. forces the router to compare the local preference of routes from different autonomous systems
C. forces the router to compare the weight of routes from different autonomous systems
D. forces the router to compare the communities of routes from different autonomous systems

Correct Answers: A

QUESTION 383
An administrator is redistributing OSPF into RIP. RIP is routing the 128.103.36.0/24 network. OSPF is routing the 128.103.35.32/28 network. Users in the RIP domain cannot reach devices in the OSPF domain. Which two tasks must be done to enable RIP to advertise the routes learned from OSPF into the RIP domain? (Choose two.)

A. Add a static route that points to the RIP domain address space with a /24 network mask and a next hop of 128.103.36.2.
B. Add a static route that points to the OSPF domain address space with a /24 network mask with a next hop of null0.
C. Tune the OSPF default metrics to allow seamless redistribution into RIP.
D. Redistribute configured static routes into RIP.
E. Use a route map statement inserted into a distribute list to control routing updates.

Correct Answers: BD

QUESTION 384
Refer to the exhibit. Which two statements are true about the partial configuration that is shown? (Choose two.)

A. The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address 10.0.0.6.
B. The first DHCP client to connect to the FastEthernet 0/1 interface will receive the IP address 10.10.0.1.
C. The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address 10.0.0.1
D. Hosts connected to the FastEthernet0/1 interface will not receive DHCP replies from the router.
E. DHCP requests received on the FastEthernet 0/1 interface will be forwarded to 10.0.0.2.

Correct Answers: AD

QUESTION 385
Refer to the exhibit. EIGRP is enabled on all routers on the network. What additional configuration is required for the routers connected over the Frame Relay multipoint interfaces to compensate for a low-speed NBMA connection?

A. Configure the EIGRP hello interval on all Frame Relay interfaces to 5 seconds.
B. Configure the EIGRP hello interval on all Frame Relay interfaces to 60 seconds.
C. Configure the EIGRP hold time on all Frame Relay interfaces to 15 seconds.
D. Configure the EIGRP hold time on all Frame Relay interfaces to 180 seconds.
E. Configure the bandwidth on all EIGRP Frame Relay interfaces to the committed information rate (CIR).
F. Configure the bandwidth on all EIGRP Frame Relay interfaces to the lowest CIR multiplied by the number of PVCs for the multipoint connection.

Correct Answers: F

Ensurepass offers the Latest 2013 642-902 Exam PDF to pass the exams.