Cisco CCNP 642-902 Exam 70

Ensurepass

QUESTION
Which three steps are most helpful in verifying proper route redistribution? (Choose three.)

A. On the routers not performing the route redistribution, use the show ip route command to see if the redistributed routes show up.
B. On the ASBR router performing the route redistribution, use the show ip protocol command to verify the redistribution configurations.
C. On the ASBR router performing the route redistribution, use the show ip route command to verify that the proper routes from each routing protocol are there.
D. On the routers not performing the route redistribution, use the show ip protocols command to verify the routing information sources.
E. On the routers not performing the route redistribution, use the debug ip routing command to verify the routing updates from the ASBR.

Correct Answer: ABC

QUESTION 342
A router is configured for redistribution to advertise EIGRP routes into OSPF on a boundary router. Given the configuration:

What is the function of the 25 parameter in the redistribute command?

A. It specifies the seed cost to be applied to the redistributed routes.
B. It specifies the administrative distance on the redistributed routes.
C. It specifies the metric limit of 25 subnets in each OSPF route advertisement.
D. It specifies a new process-id to inject the EIGRP routes into OSPF.

Correct Answer: A

QUESTION 343
Refer to the exhibit.

R1 and R2 belong to the RIP routing domain that includes the networks 10.20.0.0/16 and 10.21.0.0/16. R3 and R4 are performing two-way route redistribution between OSPF and RIP. A network administrator has discovered that R2 is receiving OSPF routes for the networks 10.20.0.0/16 and 10.21.0.0/16 and a routing loop has occurred. Which action will correct this problem?

A. Apply an inbound ACL to the R2 serial interface.
B. Change the RIP administrative distance on R3 to 110.
C. Configure distribute-lists on R3 and R4.
D. Set the OSPF default metric to 20.
E. Change the OSPF administrative distance on R3 to 110.

Correct Answer: C

QUESTION 344
Observe the exhibit. If the command variance 3 were added to RTE, which path or paths would be chosen to route traffic to network X?

A. E-B-A
B. E-B-A and E-C-A
C. E-C-A and E-D-A
D. E-B-A, E-C-A and E-D-A

Correct Answer: B

QUESTION 345
Which three statements are true regarding EIGRP? (Choose three.)

A. By default, EIGRP performs auto-summarization across classful network boundaries.
B. EIGRP uses an area hierarchy to increase network scalability.
C. To speed convergence, EIGRP attempts to maintain a successor and feasible successor path for each destination.
D. EIGRP uses hellos to establish neighbor relationships.
E. By default, EIGRP uses the Dijkstra algorithm to determine the best path to a destination network based on bandwidth and delay.

Correct Answer: ACD

Ensurepass offers the Latest 2013 642-902 Exam PDF to pass the exams.