Cisco CCNP 642-902 Exam 57

Ensurepass

QUESTION
Refer to the exhibit.

A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up. What did the TAC engineer configure incorrectly?

A. The crypto isakmp configuration is not correct.
B. The crypto map configuration is not correct.
C. The network 172.16.1.0 is not included in the OSPF process.
D. The interface tunnel configuration is not correct.

Correct Answer: A

QUESTION 277
Refer to the exhibit. ROUTE.com is planning to implement a secure OSPF network to support traffic between clients on the 172.16.10.0/24 network and the file server on the 172.16.20./24 network. You have been asked to review the implementation and verification plans. Which statement about the plan is true?

A. It is complete as written.
B. It should include a task that verifies that the interarea routes are using the proper MED.
C. The plan should include a task that verifies that load sharing is active on the appropriate links.
D. The plan should include a task that verifies end-to-end connectivity between the clients and the file server.

Correct Answer: D

QUESTION 278
Click and drag the BGP attribute characterization on the left to the correct BGP attribute on the right.

Correct Answer:

QUESTION 279
What is the sequence, from first to last, that OSPF will follow when choosing a router ID?

A. 1. the highest IP address on any active loopback interface;
2. The router-id command results;
3.The highest IP address of any active physical interface.

B. 1. the highest IP address on any active loopback interface;
2. The highest IP address of any active Physical interface;
3. The router-id command result.

C. 1. The highest IP address of any active Physical interface;
2. the highest IP address on any active loopback interface;
3. The router-id command results.

D. 1. The highest IP address of any active Physical interface;
2. The router-id command result;
3.The highest IP address of any active physical interface.
E. 1. The router-id command results;
2. The highest IP address of any active Physical interface;
3. The highest IP address of any active physical interface.

F. 1. The router-id command result;
2. The highest IP address on any active loopback interface;
3. The highest IP address of any active physical interface.

Correct Answer: F

QUESTION 280
Click the resources on the left that you need to create an implementation plan for an OSPF project and drag them to the target zone on the right.

Correct Answer:

Ensurepass offers the Latest 2013 642-902 Exam PDF to pass the exams.