Cisco CCNP 642-902 Exam 45

Ensurepass

QUESTION
Refer to the exhibit.

What is required to complete the IPv6 routing configurations shown?

A. Interface authentication must be configured.
B. The routing processes must be configured with an area ID.
C. IP unicast routing must be enabled.
D. IPv4 addresses must be applied to the interfaces.

Correct Answer: C

QUESTION 217
Which functionality is required within an IP router that is situated at the boundary of an IPv4 network and an IPv6 network to allow communication between IPv6-only and IPv4-only nodes?

A. Autoconfiguration
B. Automatic 6to4 Tunnel
C. Automatic 6to4 Relay
D. Network Address Translator-Protocol Translator (NAT-PT)
E. Intrasite Automatic Tunnel Address Protocol (ISATAP)

Correct Answer: D

QUESTION 218
During the IPv6 auto configuration, what does the device append to the 64-bit prefix that it receives from the router to create its IPv6 address?

A. a pseudorandom generated number
B. its locally configured IPv4 address
C. the DHCP-supplied device ID
D. its MAC address

Correct Answer: D

QUESTION 219
Refer to the exhibit.

Which statement about this neighbor of R1 is true?
A. OSPFv3 adjacency has been lost, which causes the neighbor to be considered Stale.
B. Aggregate global addresses are always used between IPv6 neighbors.
C. OSPFv3 adjacency will not work between link-local addresses.
D. R1 used ICMP to learn about this neighbor.

Correct Answer: D

QUESTION 220
Which three are characteristics of IPv6? (Choose three.)

A. An IPv6 address is 128 bits long.
B. An IPv6 header is 20 bits long.
C. An IPv6 header contains the next header field.
D. An IPv6 header contains the protocol field.
E. IPv6 routers send RA messages.
F. An IPv6 header contains the header checksum field.

Correct Answer: ACE

Ensurepass offers the Latest 2013 642-902 Exam PDF to pass the exams.