Cisco CCNP 642-902 Exam 16

Ensurepass

QUESTION
Which of the following are methods EIGRP uses to initially populate (seed) its EIGRP topology table, before learning topology data from neighbors? (Choose two.)

A. By adding all subnets listed by the show ip route connected command
B. By adding the subnets of working interfaces over which static neighbors have been defined
C. By adding subnets redistributed on the local router from another routing source
D. By adding all subnets listed by the show ip route static command

Correct Answer: BC

QUESTION 72
An engineer has added the following configuration snippet to an implementation planning document. The configuration will be added to Router R1, whose Fa0/0 interface connects to a LAN to which Routers R2 and R3 also connect. R2 and R3 are already EIGRP neighbors with each other. Assuming the snippet shows all commands on R1 related to EIGRP authentication, which answer lists an appropriate comment to be made during the implementation plan peer review?

A. The configuration is missing one authentication-related configuration command.
B. The configuration is missing two authentication-related configuration commands.
C. Authentication type 9 is not supported; type 5 should be used insteaD.
D. The key numbers must begin with key 1, so change the key 3 command to key 1.

Correct Answer: A

QUESTION 73
Which of the following settings could prevent two potential EIGRP neighbors from becoming neighbors? (Choose two)

A. The interface used by one router to connect to the other router is passive in the EIGRP process.
B. Duplicate EIGRP router IDs
C. Mismatched Hold Timers.
D. IP addresses of 10.1.1.1/24 and 10.2.2.2/24, respectively.

Correct Answer: AD

QUESTION 74
Based on the need to limit processing and bandwidth utilization due to dynamic routing protocol operation, the following routing requirements have been specified for your network.

Which dynamic routing protocol should be deployed in your network to best meet these requirements?

A. BGP
B. OSPF
C. IS-IS
D. EIGRP
E. RIPv2

Correct Answer: D

QUESTION 75
Refer to the exhibits.

Router B should advertise the network connected to the E0/0/0 interface to router A and block all other network advertisements. The IP routing table on router A indicates that it is not receiving this prefix from router B. What is the probable cause of the problem?

A. An access list on router B is causing the 192.168.3.16/28 network to be denied.
B. An access list on router B is causing the 192.168.3.32/28 network to be denied.
C. The distribute list on router B is referencing a numbered access list that does not exist on router
D. The distribute list on router B is referencing the wrong interface. E.

Correct Answer: A

Ensurepass offers the Latest 2013 642-902 Exam PDF to pass the exams.