Cisco CCNP 642-902 Exam 13

Ensurepass

QUESTION
Refer to the exhibit.

EIGRP had converged in AS 1 when the link between router R1 and R2 went down. The console on router R2 generated the following messages:

*Mar 20 12:12:06: %DUAL-5-NBRCHANGE. IP-EIGRP 1: Neighbor 10.1.4.3 (Serial0) is down:
stuck in active
*Mar 20 12:15:23: %DUAL-3-SIA. Route 10.1.1.0/24 stuck-in-active state in IP-EIGRP 1. Cleaning up

The network administrator issued the show ip eigrp topology active command on R2 to check the status of the EIGRP network. Which statement best describes the reason for the error messages?

A. Incorrect bandwidth configuration on router R3 prevents R2 from establishing neighbor adjacency.
B. Incorrect bandwidth configuration on router R5 prevents R2 from establishing neighbor adjacency.
C. Router R3 did not reply to the query about network 10.1.1.0/24 sent by router R2 .
D. Router R5 did not reply to the query about network 10.1.1.0/24 sent by router R2 .

Correct Answer: C

QUESTION 57
Which EIGRP packet statement is true?

A. On high-speed links, hello packets are broadcast every 5 seconds for neighbor discovery.
B. On low-speed links, hello packets are broadcast every 15 seconds for neighbor discovery.
C. Reply packets are multicast to IP address 224.0.0.10 using RTP.
D. Update packets route reliable change information only to the affected routers.
E. Reply packets are used to send routing updates.

Correct Answer: D

QUESTION 58
Refer to the exhibit.

EIGRP has been configured on all routers in the network. The command metric weights 0 0 1 0 0 has been added to the EIGRP process so that only the delay metric is used in the path calculations. Which router will R1 select as the successor and feasible successor for Network A?

A. R4 becomes the successor for Network A and will be placed in the routing table. R2 becomes the feasible successor for Network A.
B. R4 becomes the successor for Network A and will be included in the routing table. No feasible successor will be selected as the advertised distance from R2 is higher than the feasible distance.
C. R2 becomes the successor and will be placed in the routing table. R4 becomes the feasible successor for Network A.
D. R2 becomes the successor and will be placed in the routing table. No feasible successor will be selected as the reported distance from R4 is lower than the feasible distance.

Correct Answer: B

QUESTION 59
During a redistribution of routes from OSPF into EIGRP, an administrator notices that none of the OSPF routes are showing in EIGRP. What are two possible causes? (Choose two.)

A. incorrect distribute lists have been configured
B. missing ip classless command
C. CEF not enabled
D. no default metric configured for EIGRP

Correct Answer: AD

QUESTION 60
Refer to the exhibit.

What must be done on router RTA to ensure that EIGRP works effectively in a Frame Relay multipoint environment?

A. Issue the command bandwidth 56 on each subinterface.
B. Issue the command bandwidth 224 on each subinterface.
C. Issue the command bandwidth 56 on the physical interface.
D. Issue the command bandwidth 224 on the physical interface.

Correct Answer: D

Ensurepass offers the Latest 2013 642-902 Exam PDF to pass the exams.